C
Use the mounting screw to x the milling bur holder in place.
D
Set the cleaning tool in the "Cleaning" stocker.
Insert the cleaning tool into the stocker slowly and from directly above the stocker to prevent the
bristles from catching on the stocker and spreading out.
CAUTION
Do not needlessly insert or remove the cleaning tool.
Replacing the cleaning tool
If the cleaning tool bristles spread out, the tool's eectiveness at removing milling waste will be reduced. If the
bristles have spread out, replace the cleaning tool with a new one.
Contact your authorized DGSHAPE Corporation dealer or visit our website (http://www.dgshape.com/) to
purchase items.
" P.77 "Replacing the Cleaning Tool"
Starting Milling
48
Chapter 2 Milling
To Next Page
Loading...
