EasyManua.ls Logo

Dieci APOLLO MINI AGRI - Brake: Coolant Level Check; Wheel Maintenance; Epicycloidal Reduction Gear Oil: Check and Replacement

Dieci APOLLO MINI AGRI
313 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11 | Maintenance
206 AXH1230‐UK ﴾ENG﴿ ‐ Apollo KM
11.13.2 Brake: Coolant level check
Whentheindicatorlightflashesonthecentralinstrumentpanel
(fig. 1507091: Brake oil level low) it means that the brake fluid
level has dropped below the minimum (MIN) and therefore it
mustberestored.
Periodically check the tank 1” (fig. 1507092) that is located
behindtheseat.
WARNING! If the light stays on even after adding oil,
contact a Dieci authorized service center to solve the
problem.
Aslightloweringofthelevelisduetonormalwearofthebrake
discs.
Donotpressthebrakepedaluntilthetoppingupiscompleted.
Makesurethetankisclosedbeforeactingonthepedal.
150709-2
150709-1
DANGER
The significant lowering of the level is an indication of leakage in the system. Refer to
qualified staff for the replacement of any damaged, corroded or ruined pipe.
It is absolutely forbidden to operate with brake oil level below the minimum "MIN". The brakes may
operate erratically with the risk of accidents.
CAUTION
Type and source of hazard
Always use oil of the prescribed grade, as indicated in "Technical data" chapter.
This type of oil can damage painted surfaces and plastic parts of the instrument panel. For safety
precautions, refer to the "Safety regulations" chapter.
11.14 Wheel maintenance
11.14.1 Epicycloidal reduction gear oil: Check and replacement
Theoilcapoftheepicycloidalreductiongear is located on the
hubofthewheel(fig.1505771):
When checking the oil level it is necessary to:
Preparethevehicleinthemaintenanceposition.
Turnthewheelfortheoilcaptobeinthehorizontalposition
(9o'clock).
Placeacontainertocollecttheoil.
Removethecapandverifythattheoilseepsfromthehole.
Ifnecessary,topupthroughthesamehole.
Closethecapandtightenitsecurely.
When replacing the oil it is necessary to:
Preparethevehicleinthemaintenanceposition.
150577-1

Table of Contents

Related product manuals