AT commands Zigbee Addressing commands
Digi XBee® 3 Zigbee® RF Module
190
Default
0 - 0xFFFE
MP (16-bit Parent Network Address)
Read the 16-bit network address of the device's parent. A value of 0xFFFE means the device does not
have a parent.
Read the 16-bit network address of the device’s parent.
If MP=0xFFFE, the device is not an End Device or is not currently associated with a parent.
Parameter range
0 - 0xFFFE [read-only]
Default
0xFFFE
DH (Destination Address High)
Set or read the upper 32 bits of the 64-bit destination address.
When you combine DH with DL, it defines the 64-bit destination address that the device uses for
outgoing data transmissions in transparent mode (AP=0) and I/O sampling. This destination address
corresponds to the serial number (SH + SL) of the target device.
Reserved Zigbee network addresses:
n 0x000000000000FFFF is a broadcast address.
n 0x0000000000000000 addresses the network coordinator.
Parameter range
0 - 0xFFFFFFFF
Default
0
DL (Destination Address Low)
Set or display the lower 32 bits of the 64-bit destination address.
When you combine DH with DL, it defines the 64-bit destination address the device uses for outgoing
data transmissions in transparent mode (AP = 0) and I/O sampling. This destination address
corresponds to the serial number (SH + SL) of the target device.
Reserved Zigbee network addresses:
n 0x000000000000FFFF is a broadcast address.
n 0x0000000000000000 addresses the network coordinator.
Parameter range
0 - 0xFFFFFFFF
Default
0
To Next Page
Loading...
