Digi XBee 3 ZigBee - Custom Default Commands

AT commands Custom default commands
Digi XBee® 3 Zigbee® RF Module
231
Default
N/A
RE (Restore Defaults)
Restore all device parameters to factory defaults but do not apply the parameters.
Parameter range
N/A
Default
N/A
Custom default commands
The following commands are used to assign custom defaults to the device. Send RE (Restore Defaults)
to restore custom defaults. You must send these commands as local AT commands, they cannot be
set using Remote AT Command Request frame - 0x17.
%F (Set Custom Default)
When %F is received, the XBee 3 Zigbee RF Module takes the next command received and applies it to
both the current configuration and the custom defaults, so that when defaults are restored with RE
(Restore Defaults) the custom value is used.
Parameter range
N/A
Default
N/A
!C (Clear Custom Defaults)
Clears all custom defaults. This command does not change the current settings, but only changes the
defaults so that RE (Restore Defaults) restores settings to the factory values.
Parameter range
N/A
Default
N/A
R1 (Restore Factory Defaults)
Restores factory defaults, ignoring any custom defaults set using %F (Set Custom Default).
Parameter range
N/A
Default
N/A