Digi XBee 3 ZigBee - Diagnostic Commands

AT commands Diagnostic commands
Digi XBee® 3 Zigbee® RF Module
227
LX (Location X)
User-defined GPS latitude coordinates of the node that is displayed on Digi Remote Manager and
Network Assistant.
Parameter range
0 - 15 ASCII characters
Default
One ASCII space character (0x20)
LY (Location Y)
User-defined GPS longitude coordinates of the node that is displayed on Digi Remote Manager and
Network Assistant.
Parameter range
0 - 15 ASCII characters
Default
One ASCII space character (0x20)
LZ (Location Z)
User-defined GPS elevation of the node that is displayed on Digi Remote Manager and Network
Assistant.
Parameter range
0 - 15 ASCII characters
Default
One ASCII space character (0x20)
Diagnostic commands
The following read-only commands are diagnostics that provide more information about the device.
VR (Firmware Version)
Reads the firmware version on a device as a 4-digit hex number.
Parameter range
0 - 0xFFFF [read-only]
Default
Set in the firmware
VL (Version Long)
Shows detailed version information including the application build date and time.