Digi XBee 3 ZigBee - IO Settings Commands

AT commands I/O settings commands
Digi XBee® 3 Zigbee® RF Module
214
Parameter Child table timeout
0 10 seconds
1 2 minutes
2 4 minutes
3 8 minutes
4 16 minutes
5 32 minutes
6 64 minutes
7 128 minutes
8 256 minutes
9 512 minutes
10 1024 minutes
11 2048 minutes
12 4096 minutes
13 8192 minutes
14 16384 minutes
Default
1
SI (Sleep Immediately)
Executable command. Causes a cyclic sleep device to sleep immediately rather than wait for the ST
timer to expire.
Note If you issue this command in Command mode, the module remains in Command mode until the
CT timer expires or you issue a CN command.
Parameter
N/A
Default
N/A
I/O settings commands
The following commands configure the various I/O lines available on the XBee 3 Zigbee RF Module.
D0 (DIO0/AD0/Commissioning Button Configuration)
Sets or displays the DIO0/AD0/CB configuration (Micro pin 31/SMT pin 33/TH pin 20).