doble SFRA - Figure D.2 Blade in Top of Fuse Cover; Figure D.3 Open Fuse Cover with Fuses in Place

Sweep Frequency Response Analyzer (SFRA) User Guide
D-2 72A-2570-01 Rev. K 07/2011
To replace a fuse:
1. Insert a flat blade behind the top of the fuse cover (Figure D.2).
Figure D.2 Blade in Top of Fuse Cover
The fuse cover is hinged at the bottom.
2. Pull the fuse cover out and down (Figure D.3).
Figure D.3 Open Fuse Cover with Fuses in Place
Note that the arrows on the fuses match the arrows printed on the inside of
the cover.
3. Replace the fuses, making sure to match the arrows on the fuses to the
arrows on the cover, and close the cover.