AssuredSAN 4004 Series Setup Guide 99
Can you replicate a volume?
Can you view a replication image?
Can you view remote systems?
Answer Possible reasons Actions
Yes System functioning properly. No action required.
No AssuredRemote is not licensed on
each controller enclosure used for
replication.
See actions described in Can you successfully use the
replication feature? on page 97.
No Nonexistent replication set. • Determine existence of primary or secondary volumes.
• If a replication set has not been successfully created, use
the Replication Setup Wizard to create one.
• Review event logs (in the Configuration View panel,
right-click the system, and select View > Event Log) for
indicators of a specific fault in a replication data path
component. Follow any Recommended Actions.
No Network error occurred during
in-progress replication.
• Review event logs for indicators of a specific fault in a
replication data path component. Follow any
Recommended Actions.
• In the Configuration View panel, right-click the secondary
volume, and select View > Overview to display the
Replication Volume Overview table:
• Check for replication interruption (suspended) status.
• Check for inconsistent status.
•Check for offline status.
• Replications that enter the suspended state must be resumed
manually.
No Communication link is down. See actions described in Can you view information about
remote links? on page 97.
Table 30 Diagnostics for replication setup: Replicating a volume (v2)
Answer Possible reasons Actions
Yes System functioning properly. No action required.
No Nonexistent replication image. • In the Configuration View panel, expand disk groups and
subordinate volumes to reveal the existence of a replication
image or images.
• If a replication image has not been successfully created,
use RAIDar to create one as described in the “Using
AssuredRemote to replicate volumes” topic within the
Storage Management Guide.
No Communication link is down. See actions described in Can you view information about
remote links? on page 97.
Table 31 Diagnostics for replication setup: Viewing a replication image (v2)
Answer Possible reasons Actions
Yes System functioning properly. No action required.
No Communication link is down. See actions described in Can you view information about
remote links? on page 97.
Table 32 Diagnostics for replication setup: Viewing a remote system (v2)
To Next Page
Loading...