Installation
SmartDate X40 BFSE Version 1.0 Feb 2011
83/286
Encoder Installation
Installing the encoder assembly
Fasten the encoder to the encoder
arm using the three encoder retaining
screws
There are 12 positions to allow the
cable exit to be positioned correctly
Secure the encoder wheel to the shaft
by sliding the encoder wheel over the
end of the encoder with the grub
screws facing upwards
Secure the wheel in place by
tightening the two set screws
Screw the encoder stand-off (M8
thread) onto the Printer bracket into a
suitable position using a 13mm open
ended spanner
To Next Page
Loading...
