Rho 1012/1030 EOperation
3.4.2 Adjusting the passing height
The passing height (gap between the front stop and the conveyor belt) has to
be adjusted depending on the thickness of the plate medium.
Fig. 19 Adjusting the passing height
1. Loosen the fixing sc rew (2).
2. Use the lever (1) to adjust the height of the front stop (3 ).
3. Tighten the fixing screw.
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/10 30 , Issued 07/2013 41 / 147
To Next Page
Loading...
