Rho 1012/1030 EOperation
Automatic: Loading of thin flexible plate media for serial printing
Semi-automatic:
–Thin,flexible plate media
– Mirror-inverted printing of the rear
Manual mode: P late media with excess length
10.1.1 Loading plate m edia in autom atic mode
✔ In the software Continuous Feeding is activated in the media channel
1. Adjusting the front stop (→ Page 40 / Adjusting the front stop)
2. Set the feed table at the operator panel to automatic mode.
1
Fig. 37 Laying media on the load position
3. Lay the desired number of plate media stacked on the feed table.
Proceed as follows:
–Laythefirst track against the right-hand guides (1).
– Lay all further tracks to the left. Lay the plate media between the
swivel stops in the process.
4. Load the desired media channel in the software.
5. Start printing process
in the software.
6. Lay further media on the feed table while the media are being drawn in.
The media are transported automatically to the printer.
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/10 30 , Issued 07/2013 71 / 147
To Next Page
Loading...
