Rho 1012/1030 EOperation
10.1.3 L oading a plate medium in manual mode
✔ In the software Continuous Feeding is deactivated in the media channel
1. Removethefrontstop,ifnecessary,oradjustitsothatdrawing-inofthe
plate medium is not impaired (→ Page 40 / Adjusting the front stop).
2. Move the rolls upward at the operator panel for m anual mode.
3. Load the desired media channel in the software. Take the following into
consideration: If a plate medium is to be printed with left stop (e.g. for
back printing), this option has to be activated in the media channel.
Fig. 39 Laying the medium against the guides and pins (here: right
stop)
4. Lay the plate medium against the guides (1)
. By default the guides on
the right-hand side are used, in case of le
ft stop (for example for back
printing) the gu ides on the le ft-ha
nd side.
5. Push the plate medium manually to the printer.
2004 – 2013 © Durst Phototechnik AG – www.durst-online.com , Rho 1012/10 30 , Issued 07/2013 73 / 147
To Next Page
Loading...
