OPERATION
3-38 25364 Issue 8 March 2018
If it has been set to Manual, the number of millimetres the printer should
pull back the ribbon must be defined. Measure the desired pull back before
entering a value to avoid entering an overly high value causing prints to
overlap on the ribbon.
Retraction Length (CM only) The way in which this field is displayed on
the screen depends on how Retraction Type has been set. If it is set to off,
the field is greyed out.
If Retraction Type has been set to Auto, Retraction Offset must be set in this
menu.
If Retraction Type has been set to Manual, Retraction Length must be set in
this field.
Retraction Offset A Retraction Offset of -1 is recommended.
To Next Page
Loading...
