Serinus® 30 User Manual 3.3
2. Start the Client, Server and Download Server by single-clicking the toggle button for each. The
client may prompt to register with Ecotech or install an update. Follow the prompts if it does.
3. Once the Client application has loaded, click Home → Add Station → New Physical Station.
Figure 93 – Adding a New Station
4. This automatically brings the user to the Station tab on the ribbon. Enter the communication
details to connect to the instrument.
Figure 94 – New Station Connection
Table 7 – New Station Setup
The name of the station. If the user has other loggers, the
name is used to distinguish them.
Set this to “Ecotech Serinus” when downloading from any
Serinus series instrument. This will communicate with the
instrument via the Advanced protocol. If using a network or
serial connection, ensure that the Advanced protocol has also
been selected on the instrument itself.
Set this to the time zone that the instrument is located in.
Enable this option if the user plans on changing the clock on
the instrument with daylight savings. Leave this disabled if
the clock does not shift during DST. The instrument will need
to be adjusted manually for DST – it will not happen
automatically.
To Next Page
Loading...
