Ecotech Acoem Serinus 30 - Instrument Set-Up; Figure 36 - Installation of USB Memory Stick; Figure 37 - Travel Screw Locations; Figure 38 - Switching the Battery ON;OFF

Serinus® 30 User Manual 3.3
Page 46
2.3.4 Instrument Set-Up
1. Refer to Figure 36. Open the lid and make sure the USB memory stick is installed.
Figure 36 – Installation of USB Memory Stick
2. Refer to Figure 37. Remove the travel screws from the measurement cell (store in a zip lock bag
within the analyser).
Figure 37 – Travel Screw Locations
3. Refer to Figure 38. Check that the battery switch is turned ON at the main controller PCA.
Figure 38 – Switching the Battery ON/OFF