CAUTION
11. When installing this instrument ensure that appropriate lifting
equipment and procedures are followed. It is recommended that two people lift
the instrument into the rack due to the weight, unless proper lifting equipment is
available.
9. Push the instrument into the rack. Adjust and tighten the screws as required to achieve a smooth
and secure slide.
To Remove the Instrument
1. To remove the instrument first pull instrument forward of rack giving access to the slides.
2. Find the rack slide lock labelled Push and push it in whilst sliding the instrument out of the rack,
complete this for both sides while carefully removing instrument.
Figure 155 – Slide Clips
8.4 Internal Pump (PN: E020107)
8.4.1 Hardware Setup
This procedure should be followed after a factory reset.
Equipment Required
• NA
Procedure
1. Press - (the green instrument status light), to return to the home screen.
2. Press - (-99+) on the keypad to open the Advanced Menu.
3. Open - Advanced Menu → Hardware Menu.
4. Enable - Internal Pump → Enabled.
To Next Page
Loading...
