4. Input the PIN (if prompted) and press OK (refer to Section 3.4.30).
Figure 103 – Bluetooth Pairing Request
5. A screen shot of the instrument’s current screen should appear on the users smartphone or tablet.
To disconnect press the back key/button on the device.
Note: Once the instrument has been paired with the device it will appear under “Paired Devices”
and the PIN will not need to be entered again. Only one Bluetooth connection can be made to an
instrument at any one time.
4.7.3 Instrument Control
Once connected the user has full control of the instrument. The range for remote control depends on
the device’s Bluetooth capabilities and any intervening obstructions, but is usually up to 30 meters.
Remote Screen Operation
With the exception of the number pad, all button functions/actions can be performed by touching the
screen. This includes the selection buttons and the scroll buttons. Touching any part of the screen
where there is not already a button also enacts the functions of the scroll buttons.
Home Screen
Touching the upper half of the screen increases the contrast and touching the lower half of the screen
decreases contrast on the real instrument.
Menus
Touching the upper or lower half of the screen allows the user to scroll up and down respectively.
Right-hand Section of the Screen
Swiping from right to left brings up the number pad for entering numbers (swipe from left to right to
hide the number pad).
To Next Page
Loading...
