Ecotech Acoem Serinus 30 - Figure 129 - Remove Filter Sealing Cap; Figure 130 - Particulate Filter

Service
Page 143
Figure 129 – Remove Filter Sealing Cap
6. Refer to Figure 130. Remove the old particulate filter.
Figure 130 – Particulate Filter
7. If the inner surface of the sample filter components are dirty, then clean with damp lint free paper
towel.
8. Place a new particulate filter paper into the body of the sample filter holder.
Note: Make sure filter body is completely dry before placing the new filter.
Note: Avoid to touch Particulate filter paper by hand use blue paper to place the filter into filter
body.