Ecotech Acoem Serinus 30 - Chart; Figure 74 - Chart Screen

Serinus® 30 User Manual 3.3
Page 88
Name
Displays the name of the Parameter the user has selected.
Parameter
Allows the user to select any loggable (refer to Table 33) parameter
to graph on the trend display.
Autoscale
Autoscale can be ON or OFF. When it is “ON” the parameter will be
scaled automatically for user convenience based on the current
values logged.
Min
This is the minimum scale of the chart as defined by the Autoscale or
the user.
Max
This is the maximum scale of the chart as defined by the Autoscale
or the user.
Clear
Clears the current data points in the Chart.
Data Log Interval
The data log interval can be user set from 1 sec interval up to 24
hours.
Chart
This field enters a screen with a graph of the user selected
Parameter (refer to Section 3.4.32).
3.4.32 Chart
Main Menu → Trend Display Menu → Chart
The chart allows the user to select a parameter and view it in a real time chart. The user can select
from any loggable parameter (refer to Table 33). Changing the logged parameter will reset the chart.
Pressing the Up or Down buttons will change between the selected parameter and the instantaneous
CO gas value. Changing the Data Log Interval resets all charts.
Figure 74 – Chart Screen
Chart Title (1)
Displays the name of the parameter as it would be displayed on the advanced protocol parameter list.
Data Log Interval (2)
Displays the value of the data logging interval as determined by the user in the Trend Display Menu
(refer to Section 3.4.31).