Serinus® 30 User Manual 3.3
Important Safety Messages
Disconnect Power Prior to Service
Hazardous voltages exist within the instrument. Do not remove or modify any of the
internal components or electrical connections whilst the mains power is ON.
Always unplug the equipment prior to removing or replacing any components.
Replacing Parts
Replacement of any part should only be carried out by qualified personnel, using only
parts specified by Ecotech, as these parts meet stringent Ecotech quality.
Mains Supply Cord
Do not replace the detachable mains supply cord with an inadequately rated cord. Any
mains supply cord that is used with the instrument must comply with the safety
requirements (250 V/10 A minimum requirement). A mains power cord with a protective
earth conductor must be used.
Ensure that the mains supply cord is maintained in a safe working condition.
Do Not Expose Equipment to Flammable Gases
This equipment is not intended for use in explosive environments, or conditions where
flammable gases are present. The user should not expose the equipment to these
conditions. Do not introduce any flammable gases into the instrument, otherwise serious
accidents such as explosion or fire may result.
Electromagnetic Compliance
The instrument lid should be closed when in normal operation, to comply with EMC
regulations.
Means of Lifting/Carrying Instrument
This instrument is a heavy and bulky object. Two persons should lift/carry the object,
otherwise use proper lifting equipment. Proper lifting techniques should be used when
moving the instrument.
Internal Components
Do not insert a rod or finger into the cooling fans, otherwise injury may result.
Do not energise the instrument until all conductive cleaning liquids, used on internal
components, are dried up.
To Next Page
Loading...
