Ecotech Acoem Serinus 30 - Page 211

Appendix
Page 211
118
Sample Fill Time
These parameters can be changed, but only temporarily;
restarting the instrument will restore them to their default
values.
119
Sample Measure Time
120
Aux Measure Time
121
Aux Smpl. Fill Time
122
Backgnd Fill Time
123
Zero Fill Time
124
Zero Measure Time
125
Span Fill Time
126
Span Measure Time
127
O3 Gen. Coeff D
O3 Generator Coefficient D
128
Backgnd Pause Time
In seconds
129
Bkgnd Intrleav Fact
130
Cal. Pressure 2
Calibration Pressure for 2nd gas
131
2nd Instrument Gain
Only valid with an S40 variant set to multiple gains. Shows the
second gas gain (NO). Default is 1.0.
132
Background voltage
Units in Volts
133
Perm Rate
Permeation rate of the gas in ng/min
134
Perm Flow
Total flow past the permeation chamber during an activated
internal span mode. In ml/min
135
Perm Oven Setpoint
Set target temperature for the permeation oven. Default is
50°C
136
Perm Oven Temp
Temperature readout of the Permeation oven. Units in °C
137
Ozone Target
Ozone Target for S10 IZS Ozone generation
138
Conc Adjusted 1
Concentration value in PPM before filtering
139
Conc Adjusted 2
140
Conc Adjusted 3
141
Chopper Speed
Revolutions in the last second
142
Chopper Frequency
In rpm
143
IR Source
The S30 IR source voltage
144
Background (hrs)
The background interval in hours.
0.0 if disabled
0.25 for every 15 minutes
0.30 for every 20 minutes
0.50 for every 30 minutes
1.00 for every hour
24.00 for once a day
145
Cycle Time
In minutes
146
CO Cooler Pot
CO Cooler voltage adjustment POT