Ecotech Acoem Serinus 30 - Page 86

Serinus® 30 User Manual 3.3
Page 86
Set DHCP: This sets the network port into DHCP mode,
allowing the network to assign the instrument an IP address.
IP Address
[Read IP or Set IP Start-up Mode]
This is the current IP address of the instrument.
Netmask
[Read IP or Set IP Start-up Mode]
This is the subnet mask of the network the instrument is
connected to.
Gateway
[Read IP or Set IP Start-up Mode]
This is the IP address of the router to access addresses not on
the same subnet.
ID
[Set DHCP Start-up Mode]
This is the ID of the instrument. Use the keypad to edit this
field.
The default ID setting is Serinus(Ecotech ID).
The word Serinus is always the first part of the name and
cannot be edited. The second part is the Ecotech ID.
Adaptor is in DHCP mode
[Set DHCP Start-up Mode]
In this mode the instrument will ask for its network
parameters from a DHCP server on your network.
Protocol
Sets the protocol used for the network port (Advanced,
ModBus, EC9800 or Bayern-Hessen). This must be set to
Advanced for Ecotech supplied software.
Endian
[Modbus Protocol]
Select Little or Big endian mode for ModBus protocol.
Bayern-Hessen ID
[Bayern-Hessen Protocol]
This is the Bayern-Hessen ID used by the Bayern-Hessen
Protocol.
CO ID
[Bayern-Hessen Protocol]
This is the ID of the CO gas used by the Bayern-Hessen
Protocol.
CO2 ID
[Bayern-Hessen Protocol]
[Input 1 is CO2 Option]
This is the ID of the CO
2
gas used by the Bayern-Hessen
Protocol. This option is only available if the user has enabled
the Input 1 is CO2 option in the Hardware Menu (refer to
Section 3.4.34).
To read the IP address, refer to Section 4.3.1.
To set the IP address, refer to Section 4.3.2.