Acclarix LX9 Series Diagnostic Ultrasound System User Manual
Adding comments
You can add either pre-defined comments or use a keyboard.
Adding comments using the keyboard
1. Invoke the Comment function.
2. Use the keyboard of the system or press the “Keyboard...” touch screen key to display a
keyboard on the touch screen.
3. Move the cursor to the desired location and type the desired text.
Adding comments using pre-defined comments
1. Invoke the Comment function
2. Move the cursor to the desired location and press the desired pre-defined comment.
Adding arrows
1. Invoke the Comment function
2. Press Arrow button on the touch screen, or press <Cursor> button on the console to display an
arrow at the current cursor location.
3. Press the ArrowSize button to adjust the arrow size if necessary.
4. Move the arrow to the desired location. Note that while the arrow is being moved the orientation of
the arrow is fixed.
5. Rotate the <Angle> knob on the console to adjust the orientation of the arrow.
6. Press <Set> key to confirm the arrow and you can now enter text at the end of the arrow.
If the "Single arrow in comment" is unchecked in General Setup page, press on <Set> key will
confirm the arrow and display a second arrow. Repetition of this will add multiple arrows.
Modifying comments
1. Move the cursor to a desired comment, notice that an insert cursor appears in the text as the
cursor moves over an existing block of text.
2. Enter text using either the keyboard or pre-defined comments. The new comments will be added
to the old text.
Deleting comments
There are several ways to delete comments:
Move the cursor to the desired block of comments and press the Delete button on the touch
screen to delete that block of comments.
Press the Delete All button on the touch screen to remove all comments.
Press the <Clear> hard key on the console to remove all comments, body marks, and
measurements.
To Next Page
Loading...
Need help?
General
