EasyManuals Logo

Edge-Core ECS3510-52T User Manual

Edge-Core ECS3510-52T
1474 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #577 background imageLoading...
Page #577 background image
C
HAPTER
15
| IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 577 –
Figure 333: Configuring an IPv6 Address
SHOWING
IPV6ADDRESSES
Use the IP > IPv6 Configuration (Show IPv6 Address) page to display the
IPv6 addresses assigned to an interface.
CLI REFERENCES
â—† "show ipv6 interface" on page 1407
PARAMETERS
These parameters are displayed:
◆ VLAN – ID of a configured VLAN which is to be used for management
access. By default, all ports on the switch are members of VLAN 1.
However, the management station can be attached to a port belonging
to any VLAN, as long as that VLAN has been assigned an IP address.
(Range: 1-4094)
◆ IPv6 Address Type – The address type (Global, EUI-64, Link Local).
◆ IPv6 Address – An IPv6 address assigned to this interface.
In addition to the unicast addresses assigned to an interface, a node is
also required to listen to the all-nodes multicast addresses FF01::1
(interface-local scope) and FF02::1 (link-local scope).
FF01::1/16 is the transient interface-local multicast address for all
attached IPv6 nodes, and FF02::1/16 is the link-local multicast address
for all attached IPv6 nodes. The interface-local multicast address is
only used for loopback transmission of multicast traffic. Link-local
multicast addresses cover the same types as used by link-local unicast
addresses, including all nodes (FF02::1), all routers (FF02::2), and
solicited nodes (FF02::1:FFXX:XXXX) as described below.
A node is also required to compute and join the associated solicited-
node multicast addresses for every unicast and anycast address it is
assigned. IPv6 addresses that differ only in the high-order bits, e.g.
due to multiple high-order prefixes associated with different
aggregations, will map to the same solicited-node address, thereby
reducing the number of multicast addresses a node must join. In this
example, FF02::1:FF90:0/104 is the solicited-node multicast address
which is formed by taking the low-order 24 bits of the address and
appending those bits to the prefix.

Table of Contents

Other manuals for Edge-Core ECS3510-52T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS3510-52T and is the answer not in the manual?

Edge-Core ECS3510-52T Specifications

General IconGeneral
BrandEdge-Core
ModelECS3510-52T
CategoryNetwork Router
LanguageEnglish

Related product manuals