EasyManuals Logo

Edge-Core ECS3510-52T User Manual

Edge-Core ECS3510-52T
1474 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1246 background imageLoading...
Page #1246 background image
C
HAPTER
38
| Multicast Filtering Commands
MVR for IPv4
– 1246 –
COMMAND USAGE
Using this command without specifying an interface displays information
for all interfaces.
EXAMPLE
Console#show ipv6 mld throttle interface ethernet 1/3
Eth 1/3 Information
Status : TRUE
Action : Replace
Max Multicast Groups : 10
Current Multicast Groups : 0
Console#
MVR FOR IPV4
This section describes commands used to configure Multicast VLAN
Registration for IPv4 (MVR). A single network-wide VLAN can be used to
transmit multicast traffic (such as television channels) across a service
provider’s network. Any multicast traffic entering an MVR VLAN is sent to
all subscribers. This can significantly reduce to processing overhead
required to dynamically monitor and establish the distribution tree for a
normal multicast VLAN. Also note that MVR maintains the user isolation
and data security provided by VLAN segregation by passing only multicast
traffic into other VLANs to which the subscribers belong.
Table 160: Multicast VLAN Registration for IPv4 Commands
Command Function Mode
mvr Globally enables MVR GC
mvr associated-profile Binds the MVR group addresses specified in a profile to
an MVR domain
GC
mvr domain Enables MVR for a specific domain GC
mvr priority Assigns a priority to all multicast traffic in the MVR
VLAN
GC
mvr profile Maps a range of MVR group addresses to a profile GC
mvr proxy-query-interval Configures the interval at which the receiver port
sends out general queries.
GC
mvr proxy-switching Enables MVR proxy switching, where the source port
acts as a host, and the receiver port acts as an MVR
router with querier service enabled
GC
mvr robustness-value Configures the expected packet loss, and thereby the
number of times to generate report and group-specific
queries
GC
mvr source-port-mode
dynamic
Configures the switch to only forward multicast
streams which the source port has dynamically joined
GC
mvr upstream-source-ip Configures the source IP address assigned to all
control packets sent upstream
GC
mvr vlan Specifies the VLAN through which MVR multicast data
is received
GC

Table of Contents

Other manuals for Edge-Core ECS3510-52T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS3510-52T and is the answer not in the manual?

Edge-Core ECS3510-52T Specifications

General IconGeneral
BrandEdge-Core
ModelECS3510-52T
CategoryNetwork Router
LanguageEnglish

Related product manuals