C
HAPTER
35
| VLAN Commands
Editing VLAN Groups
– 1123 –
EDITING VLAN GROUPS
vlan database This command enters VLAN database mode. All commands in this mode
will take effect immediately.
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ Use the VLAN database command mode to add, change, and delete
VLANs. After finishing configuration changes, you can display the VLAN
settings by entering the show vlan command.
◆ Use the interface vlan command mode to define the port membership
mode and add or remove ports from a VLAN. The results of these
commands are written to the running-configuration file, and you can
display this file by entering the show running-config command.
EXAMPLE
Console(config)#vlan database
Console(config-vlan)#
RELATED COMMANDS
show vlan (1131)
Table 134: Commands for Editing VLAN Groups
Command Function Mode
vlan database Enters VLAN database mode to add, change, and
delete VLANs
GC
vlan Configures a VLAN, including VID, name and state VC
To Next Page
Loading...
