C
HAPTER
20
| System Management Commands
System Status
– 707 –
show banner This command displays all banner information.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show banner
EdgeCore
WARNING - MONITORED ACTIONS AND ACCESSES
R&D
Albert_Einstein - 123-555-1212
Lamar - 123-555-1219
Station's information:
710_Network_Path,_Indianapolis
ECS3510-28T
Floor / Row / Rack / Sub-Rack
3/ 10 / 15 / 12
DC power supply:
Power Source A: Floor / Row / Rack / Electrical circuit
3/ 15 / 24 / 48v-id_3.15.24.2
Number of LP: 12
Position MUX: telco-8734212kx_PVC-1/23
IP LAN: 192.168.1.1/255.255.255.0
Note: !!!!!ROUTINE_MAINTENANCE_firmware-upgrade_0100-0500_GMT-
0500_20071022!!!!!_20min_network_
Console#
SYSTEM STATUS
This section describes commands used to display system information.
Table 49: System Status Commands
Command Function Mode
show access-list tcam-
utilization
Shows utilization parameters for TCAM PE
show memory Shows memory utilization parameters NE, PE
show process cpu Shows CPU utilization parameters NE, PE
show running-config Displays the configuration data currently in use PE
show startup-config Displays the contents of the configuration file (stored
in flash memory) that is used to start up the system
PE
show system Displays system information NE, PE
show tech-support Displays a detailed list of system settings designed to
help technical support resolve configuration or
functional problems
PE
show users Shows all active console and Telnet sessions, including
user name, idle time, and IP address of Telnet clients
NE, PE
show version Displays version information for the system NE, PE
To Next Page
Loading...
Need help?
General
