C
HAPTER
36
| Class of Service Commands
Priority Commands (Layer 3 and 4)
– 1169 –
EXAMPLE
This example sets the QoS priority mapping mode to use DSCP based on
the conditions described in the Command Usage section.
Console(config)#interface ge1/1
Console(config-if)#qos map trust-mode dscp
Console(config-if)#
show qos map
cos-dscp
This command shows ingress CoS/CFI to internal DSCP map.
SYNTAX
show qos map cos-dscp interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show qos map cos-dscp interface ethernet 1/5
CoS Information of Eth 1/5
CoS-DSCP map.(x,y),x: PHB,y: drop precedence:
CoS : CFI 0 1
---------------------------------
0 (0,0) (0,0)
1 (1,0) (1,0)
2 (2,0) (2,0)
3 (3,0) (3,0)
4 (4,0) (4,0)
5 (5,0) (5,0)
6 (6,0) (6,0)
7 (7,0) (7,0)
Console#
show qos map
dscp-mutation
This command shows the ingress DSCP to internal DSCP map.
SYNTAX
show qos map dscp-mutation interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
To Next Page
Loading...
Need help?
General
