C
HAPTER
13
| Security Measures
Access Control Lists
– 367 –
BINDING A PORT TO AN
ACCESS CONTROL
LIST
After configuring ACLs, use the Security > ACL (Configure Interface –
Configure) page to bind the ports that need to filter traffic to the
appropriate ACLs. You can assign one IP access list and one MAC access list
to any port.
CLI REFERENCES
â—† "ip access-group" on page 948
â—† "show ip access-group" on page 949
â—† "mac access-group" on page 960
â—† "show mac access-group" on page 961
â—† "Time Range" on page 762
COMMAND USAGE
â—† This switch supports ACLs for ingress filtering only.
â—† You only bind one ACL to any port for ingress filtering.
PARAMETERS
These parameters are displayed:
◆ Type – Selects the type of ACLs to bind to a port.
◆ Port – Port identifier.
◆ ACL – ACL used for ingress packets.
◆ Time Range – Name of a time range.
◆ Counter – Enables counter for ACL statistics.
WEB INTERFACE
To bind an ACL to a port:
1. Click Security, ACL.
2. Select Configure Interface from the Step list.
3. Select Configure from the Action list.
4. Select IP, MAC or IPv6 from the Type list.
5. Select a port.
6. Select the name of an ACL from the ACL list.
7. Click Apply.
To Next Page
Loading...
Need help?
General
