C
HAPTER
14
| Basic Administration Protocols
Connectivity Fault Management
– 547 –
◆ Alarm Time – The time a defect must exist before a fault alarm is
issued
12
.
◆ Reset Time – The time after a fault alarm has been issued, and no
defect exists, before another fault alarm can be issued
12
.
WEB INTERFACE
To show configuration settings for the fault notification generator:
1. Click Administration, CFM.
2. Select Show Information from the Step list.
3. Select Show Fault Notification Generator from the Action list.
Figure 314: Showing Settings for the Fault Notification Generator
DISPLAYING
CONTINUITY CHECK
ERRORS
Use the Administration > CFM > Show Information (Show Continuity Check
Error) page to display the CFM continuity check errors logged on this
device.
CLI REFERENCES
â—† "show ethernet cfm errors" on page 1336
â—† "clear ethernet cfm errors" on page 1335
PARAMETERS
These parameters are displayed:
◆ Level – Maintenance level associated with this entry.
◆ Primary VLAN – VLAN in which this error occurred.
◆ MEP ID – Identifier of remote MEP.
◆ Interface – Port at which the error was recorded.
◆ Remote MAC – MAC address of remote MEP.
◆ Reason – Error types include:
â–
LEAK – MA x is associated with a specific VID list
13
, one or more of
the VIDs in this MA can pass through the bridge port, no MEP is
configured facing outward (down) on any bridge port for this MA,
12. See "Configuring CFM Maintenance Domains" on page 519.
To Next Page
Loading...
Need help?
General
