C
HAPTER
16
| IP Services
Configuring the PPPoE Intermediate Agent
– 602 –
Figure 352: Configuring Interface Settings for PPPoE Intermediate Agent
g
SHOWING PPPOE IA
STATISTICS
Use the IP Service > PPPoE Intermediate Agent (Show Statistics) page to
show statistics on PPPoE IA protocol messages.
CLI REFERENCES
â—† "clear pppoe intermediate-agent statistics" on page 862
PARAMETERS
These parameters are displayed:
◆ Interface – Port or trunk selection.
◆ Received – Received PPPoE active discovery messages.
â–
All – All PPPoE active discovery message types.
â–
PADI – PPPoE Active Discovery Initiation messages.
â–
PADO – PPPoE Active Discovery Offer messages.
â–
PADR – PPPoE Active Discovery Request messages.
â–
PADS – PPPoE Active Discovery Session-Confirmation messages.
â–
PADT – PPPoE Active Discovery Terminate messages.
◆ Dropped – Dropped PPPoE active discovery messages.
â–
Response from untrusted – Response from an interface which
not been configured as trusted.
â–
Request towards untrusted – Request sent to an interface which
not been configured as trusted.
â–
Malformed – Corrupted PPPoE message.