C
HAPTER
15
| IP Configuration
Setting the Switch’s IP Address (IP Version 6)
– 569 –
CONFIGURING THE
IPV6 DEFAULT
GATEWAY
Use the IP > IPv6 Configuration (Configure Global) page to configure an
IPv6 default gateway for the switch.
CLI REFERENCES
◆ "ipv6 default-gateway" on page 1398
PARAMETERS
These parameters are displayed:
◆ Default Gateway – Sets the IPv6 address of the default next hop
router.
■
An IPv6 default gateway must be defined if the management station
is located in a different IPv6 segment.
■
An IPv6 default gateway can only be successfully set when a
network interface that directly connects to the gateway has been
configured on the switch.
WEB INTERFACE
To configure an IPv6 default gateway for the switch:
1. Click IP, IPv6 Configuration.
2. Select Configure Global from the Action list.
3. Enter the IPv6 default gateway.
4. Click Apply.
Figure 330: Configuring the IPv6 Default Gateway
CONFIGURING IPV6
INTERFACE SETTINGS
Use the IP > IPv6 Configuration (Configure Interface - VLAN) page to
configure general IPv6 settings for the selected VLAN, including auto-
configuration of a global unicast interface address, explicit configuration of
a link local interface address, the MTU size, and neighbor discovery
protocol settings for duplicate address detection and the neighbor
solicitation interval.
CLI REFERENCES
◆ "IPv6 Interface" on page 1397
◆ "DHCP Client" on page 1375
To Next Page
Loading...
