C
HAPTER
14
| Basic Administration Protocols
Connectivity Fault Management
– 539 –
DISPLAYING DETAILS
FOR LOCAL MEPS
Use the Administration > CFM > Show Information (Show Local MEP
Details) page to show detailed CFM information about a local MEP in the
continuity check database.
CLI REFERENCES
◆ "show ethernet cfm maintenance-points local detail mep" on page 1328
PARAMETERS
These parameters are displayed:
◆ MD Index – Domain index. (Range: 1-65535)
◆ MA Index – MA identifier. (Range: 1-2147483647)
◆ MEP ID – Maintenance end point identifier. (Range: 1-8191)
◆ MD Name – The maintenance domain for this entry.
◆ MA Name – Maintenance association to which this remote MEP
belongs.
◆ MA Name Format – The format of the Maintenance Association name,
including primary VID, character string, unsigned Integer 16, or
RFC 2865 VPN ID.
◆ Level – Maintenance level of the local maintenance point.
◆ Direction – The direction in which the MEP faces on the Bridge port (up
or down).
◆ Interface – The port to which this MEP is attached.
◆ CC Status – Shows if the MEP will generate CCM messages.
◆ MAC Address – MAC address of the local maintenance point. (If a CCM
for the specified remote MEP has never been received or the local MEP
record times out, the address will be set to the initial value of all Fs.)
◆ Defect Condition – Shows the defect detected on the MEP.
◆ Received RDI – Receive status of remote defect indication (RDI)
messages on the MEP.
◆ AIS Status – Shows if MEPs within the specified MA are enabled to
send frames with AIS information following detection of defect
conditions.
◆ AIS Period – The interval at which AIS information is sent.
◆ AIS Transmit Level – The maintenance level at which AIS information
will be sent for the specified MEP.
To Next Page
Loading...
