C
HAPTER
20
| System Management Commands
Switch Clustering
– 769 –
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ The maximum number of cluster Members is 36.
◆ The maximum number of cluster Candidates is 100.
EXAMPLE
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
rcommand This command provides access to a cluster Member CLI for configuration.
SYNTAX
rcommand id member-id
member-id - The ID number of the Member switch. (Range: 1-36)
COMMAND MODE
Privileged Exec
COMMAND USAGE
◆ This command only operates through a Telnet connection to the
Commander switch. Managing cluster Members using the local console
CLI on the Commander is not supported.
◆ There is no need to enter the username and password for access to the
Member switch CLI.
EXAMPLE
Console#rcommand id 1
CLI session with the ECS3510-28T is opened.
To end the CLI session, enter [Exit].
Vty-0#
show cluster This command shows the switch clustering configuration.
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show cluster
Role : commander
Interval Heartbeat : 30
To Next Page
Loading...
