C
HAPTER
38
| Multicast Filtering Commands
MVR for IPv4
– 1260 –
show mvr
associated-profile
This command shows the profiles bound the specified domain.
SYNTAX
show mvr [domain domain-id] associated-profile
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Displays profiles bound to all MVR domains.
COMMAND MODE
Privileged Exec
EXAMPLE
The following displays the profiles bound to domain 1:
Console#show mvr domain 1 associated-profile
Domain ID : 1
MVR Profile Name Start IP Addr. End IP Addr.
-------------------- --------------- ---------------
rd 228.1.23.1 228.1.23.10
testing 228.2.23.1 228.2.23.10
Console#
show mvr interface This command shows MVR configuration settings for interfaces attached to
the MVR VLAN.
SYNTAX
show mvr [domain domain-id] interface
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Displays configuration settings for all attached interfaces.
COMMAND MODE
Privileged Exec
EXAMPLE
The following displays information about the interfaces attached to the
MVR VLAN in domain 1:
Console#show mvr domain 1 interface
MVR Domain : 1
Flag: H - immediate leave by host ip
Port Type Status Immediate Static Group Address
-------- -------- ------------- --------- --------------------
Eth 1/ 1 Source Active/Forwarding
Eth 1/ 2 Receiver Inactive/Discarding Disabled 234.5.6.8(VLAN2)
Eth 1/ 3 Source Inactive/Discarding
Eth 1/ 1 Receiver Active/Forwarding Disabled 225.0.0.1(VLAN1)
To Next Page
Loading...
Need help?
General
