EasyManuals Logo

Edge-Core ECS3510-52T User Manual

Edge-Core ECS3510-52T
1474 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #260 background imageLoading...
Page #260 background image
C
HAPTER
9
| Congestion Control
Storm Control
– 260 –
◆ Rate – Sets the rate limit level.
(Range: 64 - 100,000 kbits per second for Fast Ethernet ports;
64 - 1,000,000 kbits per second for Gigabit Ethernet ports)
WEB INTERFACE
To configure rate limits:
1. Click Traffic, Rate Limit.
2. Set the interface type to Port or Trunk.
3. Enable the Rate Limit Status for the required interface.
4. Set the rate limit for the individual ports.
5. Click Apply.
Figure 120: Configuring Rate Limits
STORM CONTROL
Use the Traffic > Storm Control page to configure broadcast, multicast, and
unknown unicast storm control thresholds. Traffic storms may occur when
a device on your network is malfunctioning, or if application programs are
not well designed or properly configured. If there is too much traffic on
your network, performance can be severely degraded or everything can
come to complete halt.
You can protect your network from traffic storms by setting a threshold for
broadcast, multicast or unknown unicast traffic. Any packets exceeding the
specified threshold will then be dropped.
CLI REFERENCES
â—† "switchport packet-rate" on page 1022
COMMAND USAGE
â—† Broadcast Storm Control is enabled by default.

Table of Contents

Other manuals for Edge-Core ECS3510-52T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS3510-52T and is the answer not in the manual?

Edge-Core ECS3510-52T Specifications

General IconGeneral
BrandEdge-Core
ModelECS3510-52T
CategoryNetwork Router
LanguageEnglish

Related product manuals