Edge-Core ECS3510-52T User Manual

C HAPTER 26 | Interface Commands
Interface Configuration
– 981 –
EXAMPLE
This example shows the configuration setting for port 1.
Console#show interfaces switchport ethernet 1/1
Information of Eth 1/1
Broadcast Threshold : Enabled, 500 packets/second
Multicast Threshold : Disabled
Unknown Unicast Threshold : Disabled
LACP Status : Disabled
Ingress Rate Limit : Disabled, 1000M bits per second
Egress Rate Limit : Disabled, 1000M bits per second
VLAN Membership Mode : Hybrid
Ingress Rule : Disabled
Acceptable Frame Type : All frames
Native VLAN : 1
Priority for Untagged Traffic : 0
GVRP Status : Disabled
Allowed VLAN : 1(u)
Forbidden VLAN :
802.1Q Tunnel Status : Disabled
802.1Q Tunnel Mode : Normal
802.1Q Tunnel TPID : 8100 (Hex)
Layer 2 Protocol Tunnel : None
Console#
Table 107: show interfaces switchport - display description
Field Description
Broadcast
Threshold
Shows if broadcast storm suppression is enabled or disabled; if enabled
it also shows the threshold level (page 1022).
Multicast
Threshold
Shows if multicast storm suppression is enabled or disabled; if enabled it
also shows the threshold level (page 1022).
Unknown-unicast
Threshold
Shows if unknown unicast storm suppression is enabled or disabled; if
enabled it also shows the threshold level (page 1022).
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 998).
Ingress/Egress
Rate Limit
Shows if rate limiting is enabled, and the current rate limit (page 995).
VLAN Membership
Mode
Indicates membership mode as Trunk or Hybrid (page 1128).
Ingress Rule Shows if ingress filtering is enabled or disabled (page 1127).
Acceptable Frame
Type
Shows if acceptable VLAN frames include all types or tagged frames only
(page 1126).
Native VLAN Indicates the default Port VLAN ID (page 1129).
Priority for
Untagged Traffic
Indicates the default priority for untagged frames (page 1162).
GVRP Status Shows if GARP VLAN Registration Protocol is enabled or disabled
(page 1120).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates
untagged and “(t)” indicates tagged (page 1126).
Forbidden VLAN Shows the VLANs this interface can not dynamically join via GVRP
(page 1120).
802.1Q-tunnel
Status
Shows if 802.1Q tunnel is enabled on this interface (page 1133).

Edge-Core ECS3510-52T Specifications

General

Brand	Edge-Core
Model	ECS3510-52T
Category	Network Router
Language	English