C
HAPTER
20
| System Management Commands
SMTP Alerts
– 745 –
The following example displays settings for the trap function.
Console#show logging trap
Remote Log Status : Disabled
Remote Log Facility Type : Local use 7
Remote Log Level Type : Debugging messages
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Remote Log Server IP Address : 0.0.0.0
Console#
RELATED COMMANDS
show logging sendmail (749)
SMTP ALERTS
These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
Table 56: show logging flash/ram - display description
Field Description
Syslog logging Shows if system logging has been enabled via the logging on
command.
History logging in FLASH The message level(s) reported based on the logging history
command.
History logging in RAM The message level(s) reported based on the logging history
command.
Table 57: show logging trap - display description
Field Description
Syslog logging Shows if system logging has been enabled via the logging on
command.
REMOTELOG status Shows if remote logging has been enabled via the logging trap
command.
REMOTELOG facility type The facility type for remote logging of syslog messages as
specified in the logging facility command.
REMOTELOG level type The severity threshold for syslog messages sent to a remote
server as specified in the logging trap command.
REMOTELOG
server IP address
The address of syslog servers as specified in the logging host
command.
Table 58: Event Logging Commands
Command Function Mode
logging sendmail Enables SMTP event handling GC
logging sendmail host SMTP servers to receive alert messages GC
To Next Page
Loading...
Need help?
General
