C
HAPTER
38
| Multicast Filtering Commands
MVR for IPv4
– 1254 –
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#mvr domain 1 upstream-source-ip 192.168.0.3
Console(config)#
mvr vlan This command specifies the VLAN through which MVR multicast data is
received. Use the no form of this command to restore the default MVR
VLAN.
SYNTAX
mvr [domain domain-id] vlan vlan-id
no mvr [domain domain-id] vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR multicast data is
received. This is also the VLAN to which all source ports must be
assigned. (Range: 1-4094)
DEFAULT SETTING
VLAN 1
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† This command specifies the VLAN through which MVR multicast data is
received. This is the VLAN to which all source ports must be assigned.
â—† The VLAN specified by this command must be an existing VLAN
configured with the vlan command.
â—† MVR source ports can be configured as members of the MVR VLAN
using the switchport allowed vlan command and switchport native vlan
command, but MVR receiver ports should not be statically configured as
members of this VLAN.
EXAMPLE
The following example sets the MVR VLAN to VLAN 2:
Console(config)#mvr
Console(config)#mvr domain 1 vlan 2
Console(config)#
To Next Page
Loading...
Need help?
General
