C
HAPTER
38
| Multicast Filtering Commands
MVR for IPv4
– 1252 –
EXAMPLE
The following example enable MVR proxy switching.
Console(config)#mvr proxy-switching
Console(config)#
RELATED COMMANDS
mvr robustness-value (1252)
mvr
robustness-value
This command configures the expected packet loss, and thereby the
number of times to generate report and group-specific queries. Use the no
form to restore the default setting.
SYNTAX
mvr robustness-value value
no mvr robustness-value
value - The robustness used for all interfaces. (Range: 1-255)
DEFAULT SETTING
2
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ This command is used to set the number of times report messages are
sent upstream when changes are learned about downstream groups,
and the number of times group-specific queries are sent to downstream
receiver ports.
◆ This command only takes effect when MVR proxy switching is enabled.
EXAMPLE
Console(config)#mvr robustness-value 5
Console(config)#
RELATED COMMANDS
mvr proxy-switching (1251)
To Next Page
Loading...
