Chapter 24
| Multicast Filtering Commands
MVR for IPv6
– 729 –
Example
Console(config)#mvr6 source-port-mode dynamic
Console(config)#
mvr6 upstream-
source-ip
This command configures the source IPv6 address assigned to all MVR control
packets sent upstream on the specified domain. Use the no form to restore the
default setting.
Syntax
mvr6 domain domain-id upstream-source-ip source-ip-address
no mvr6 domain domain-id upstream-source-ip
domain-id - An independent multicast domain. (Range: 1-5)
source-ip-address – The source IPv6 address assigned to all MVR6 control
packets sent upstream. This parameter must be a full IPv6 address
including the network prefix and host address bits.
Default Setting
All MVR6 reports sent upstream use a null source IP address
Command Mode
Global Configuration
Command Usage
All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing Architecture,”
using 8 colon-separated 16-bit hexadecimal values. One double colon may be used
in the address to indicate the appropriate number of zeros required to fill the
undefined fields. (Note that the IP address ff02::X is reserved.)
Example
Console(config)#mvr6 domain 1 upstream-source-ip 2001:DB8:2222:7223::72
Console(config)#
To Next Page
Loading...
Need help?
General