Chapter 26
| CFM Commands
– 774 –
ma index name-format Specifies the name format for the maintenance association
as IEEE 802.1ag character based, or ITU-T SG13/SG15 Y.1731
defined ICC-based format
CFM
ethernet cfm mep Sets an interface as a domain boundary, defines it as a
maintenance end point (MEP), and sets direction of the
MEP in regard to sending and receiving CFM messages
IC
ethernet cfm port-enable Enables CFM processing on an interface IC
clear ethernet cfm ais mpid Clears AIS defect information for the specified MEP PE
show ethernet cfm
configuration
Displays CFM configuration settings, including global
settings, SNMP traps, and interface settings
PE
show ethernet cfm md Displays configured maintenance domains PE
show ethernet cfm ma Displays configured maintenance associations PE
show ethernet cfm
maintenance-points local
Displays maintenance points configured on this device PE
show ethernet cfm
maintenance-points local
detail mep
Displays detailed CFM information about a specified local
MEP in the continuity check database
PE
show ethernet cfm
maintenance-points
remote detail
Displays detailed CFM information about a specified
remote MEP in the continuity check database
PE
Continuity Check Operations
ethernet cfm cc ma interval Sets the transmission delay between continuity check
messages
GC
ethernet cfm cc enable Enables transmission of continuity check messages within
a specified maintenance association
GC
snmp-server enable traps
ethernet cfm cc
Enables SNMP traps for CFM continuity check events GC
mep archive-hold-time Sets the time that data from a missing MEP is kept in the
continuity check database before being purged
CFM
clear ethernet cfm
maintenance-points
remote
Clears the contents of the continuity check database PE
clear ethernet cfm errors Clears continuity check errors logged for the specified
maintenance domain and maintenance level
PE
show ethernet cfm errors Displays CFM continuity check errors logged on this device PE
Cross Check Operations
ethernet cfm mep
crosscheck start-delay
Sets the maximum delay that a device waits for remote
MEPs to come up before starting the cross-check operation
GC
snmp-server enable traps
ethernet cfm crosscheck
Enables SNMP traps for CFM continuity check events, in
relation to the cross-check operations between statically
configured MEPs and those learned via continuity check
messages
GC
mep crosscheck mpid Statically defines a remote MEP in a maintenance
association
CFM
Table 157: CFM Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General