© Edwards Limited 2017. All rights reserved. Page 97
Edwards and the Edwards logo are trademarks of Edwards Limited.
Digital pressure measurements
M588-08-880 Issue D
8 Digital pressure measurements
8.1 Description
The pressure transducer assembly is fitted to the externally mounted inlet spool on pumping systems without booster
pumps via a ½ inch BSP instrument port. On combination pumps, the pressure transducer assembly is fitted to a ⅜
inch BSP instrument port on the internally mounted interspool between the pump and the booster.
Refer to Figure 71. The pressure transducer assembly consists of the active strain gauge head connected to a right
angled tubular elbow terminated with a ½ inch BSP male connector or a ⅜ inch BSP male connector as required.
Note: Refer to the Active Strain Gauge Instruction Manual - D357-25-000 for more information on the Active Strain
gauge 1000 - 1/8 NPT.
Figure 71 - Pressure transducer assembly
To Next Page
Loading...
