M588-08-880 Issue D
Page 98 © Edwards Limited 2017. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Digital pressure measurements
8.2 Physical data
Figure 72 - Pressure transducer assembly dimensions
8.3 Installation
8.3.1 Unpack and inspect
Note: The information contained within this manual covers the physical installation of the accessory only. It will
also be necessary to configure the GXS pump controller to recognise the accessory after it has been
installed. Please refer to the GXS product manual for further information.
Remove all the packaging materials and check the pressure transducer assembly for signs of damage. If the pressure
transducer assembly is damaged, notify your supplier and the carrier in writing within three days; state the Item
number of the pressure transducer assembly together with your order number and your supplier's invoice number. Do
not use the pressure transducer assembly if it is damaged.
Check that your package contains the items for the pressure transducer assembly. If any of the items are missing,
notify your supplier in writing within three days.
If the pressure transducer assembly is not to be used immediately, store as described in Section 8.4.
To Next Page
Loading...
