M588-08-880 Issue D
Page 82 © Edwards Limited 2017. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Exhaust silencer mounting assembly
6.4.3 Installation of rear silencer mounting assy
When fitting the exhaust silencer, ensure that the arrow on the exhaust Silencer body points in the direction of
the gas flow; away from the pump exhaust outlet.
Refer to Figure 60. The rear silencer is designed to be fixed to the floor at the rear of the dry pump, using suitable
fasteners (not supplied). The built-in jacking feet on the pump can be used to align the pump exhaust flange with
the exhaust silencer inlet flange. The exhaust silencer is connected using a full nipple, trapped O-rings and clamping
rings.
Figure 60 - Installation of the rear silencer
To Next Page
Loading...
