M588-08-880 Issue D
Page 56 © Edwards Limited 2017. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Inlet filters
4.4.3 Installation of the inlet filter to inlet spool/ inlet valve assembly
Note: Refer to Section 2 and 3 for details on fitting the inlet spool and inlet valve.
Refer to Figure 41.
Special attention needs to be taken for the installation of the inlet valve due to the sealing system and the removal
and refitting of the actuator to aid correct positioning.
Figure 41 - Installation of the inlet filter to inlet spool/ inlet valve assembly
Note: Figure 41 shows the orientation of the valve in the recommended position. The valve may be installed in
other orientations according to specific requirements.
To Next Page
Loading...
