© Edwards Limited 2017. All rights reserved. Page 115
Edwards and the Edwards logo are trademarks of Edwards Limited.
Pressure gauge assembly
M588-08-880 Issue D
10 Pressure gauge assembly
This gauge is for test purposes only and must be left in the closed position during normal use to avoid damage
to the gauge.
10.1 Description
The pressure gauge assembly is a 100 mm diameter liquid filled gauge with safety blow out disc and bayonet lock and
bezel window with laminated safety glass. The pressure gauge assembly is fitted with a ball valve to isolate the gauge
from fluctuations in vacuum when a reading is not required. This also increases longevity of the gauge.
10.2 Physical data
Figure 95 - Pressure gauge assembly
Table 64 - Pressure gauge assembly check list
Item Qty Description Check
1 1 Port connector
2 1 Ball valve
3 1 ½ inch BSPT hexagonal reducing nipple
To Next Page
Loading...
