© Edwards Limited 2017. All rights reserved. Page 113
Edwards and the Edwards logo are trademarks of Edwards Limited.
Temperature transmitter
M588-08-880 Issue D
9. Connect the cable directly into the free socket on the GXS controller as shown in Figure 93.
Figure 93 - Connecting to the control system
10. If there is any excess cable, loop it back on itself and secure it firmly with a cable tie. Ensure that it cannot
come in contact with the pump surfaces.
Figure 94 - Securing excess cable with a cable tie
11. Replace the covers of the GXS system.
9.5 Storage and disposal
9.5.1 Storage
If the temperature transducer will not be used immediately:
1. Clean the temperature transmitter.
2. Protect the thread and sensing probe and place the temperature transmitter in a sealed polythene bag.
3. Store in a cool dry
9.5.2 Disposal
Dispose of the temperature transmitter in accordance with all local and national safety and environmental
requirements.
To Next Page
Loading...
