FloBoss 407 Instruction Manual
Rev 5/00 1-1
SECTION 1 — GENERAL INFORMATION
1.1 SCOPE OF MANUAL
This manual describes the FloBoss
â„¢
407 Flow Manager (also called the ROC407), part of the family of
FloBoss Flow Managers manufactured by Fisher Controls. Both the Standard version and the
Measurement Canada version of the FloBoss 407 are covered in this manual. Included are the
following sections:
♦
Section 1 General Information
♦
Section 2 FloBoss 407 Base Unit
♦
Section 3 Input/Output Modules
♦
Section 4 Communications Cards
♦
Section 5 Display and Keypad
♦
Appendix A Lightning Protection Module
♦
Appendix B Multi-Variable Sensors
♦
Appendix C I/O Simulation
♦
Glossary Glossary of Terms
♦
Index Topical Index
Section 1 describes this and related manuals. Section 1 also provides a summary of the FloBoss 407
hardware, installation guidelines, and information on power consumption, startup, and keypad
operation.
Section 2 provides information and specifications concerning the two main components of the FloBoss
407, the processor board and the termination board.
Section 3 provides information and specifications for the optional I/O modules available for the FloBoss
407.
Section 4 provides information and specifications for the communications card options available for the
FloBoss 407.
Section 5 describes the operation of the keypad and the display.
Appendix A describes the optional lightning protection module.
Appendix B describes the Multi-Variable Sensors available for the FloBoss 407.
Appendix C shows various ways to set up I/O simulation for troubleshooting I/O components and
configurations.