3 Transducer Block Device Functions Proline Promass 83 FOUNDATION Fieldbus
130 Endress+Hauser
Simulation -
Unit
read only Displays the unit used for the simulation.
! Note!
Depending on the selection in the parameter "Simulation - Measurand", the
unit is taken over from the corresponding parameter "System Unit -".
Simulation - Unit read only The current unit for the simulation value in the "Simulation - Measurand
Value" parameter appears on the display.
! Note!
The unit can be selected in the "System Unit - Volume Flow" or "System
Unit - Mass Flow" parameter ( → Page 114 ff.).
Sensor - Type read only Use this parameter to view the sensor type (e.g. Promass F).
Sensor - HW
Rev.Number
read only Use this parameter to view the hardware revision number of the sensor.
Sensor - SW
Rev.No.S-DAT
read only Use this function to view the software revision number of the software used
to create the content of the S-DAT.
Sensor - HW
Identification
read only This parameter is only used for service purposes.
Sensor -
Prod.Number
read only This parameter is only used for service purposes.
Service -
Osc.Frequency
read only This parameter is only used for service purposes.
Service -
Excitation Current
AUTO - OOS This parameter is only used for service purposes.
Service -
Carrier Tube
Temperature
AUTO - OOS This parameter is only used for service purposes.
Service -
Monitoring Mode
AUTO - OOS This parameter is only used for service purposes.
Service -
Monitoring
Osc.Amplitude
AUTO - OOS This parameter is only used for service purposes.
Service -
Monitoring
Gain Amplifier
AUTO - OOS This parameter is only used for service purposes.
Service -
Monitoring
Interval
AUTO - OOS This parameter is only used for service purposes.
Service - Gas Mode AUTO - OOS This parameter is only used for service purposes.
Service - Gas Type AUTO - OOS This parameter is only used for service purposes.
Service - Sonic
Velocity
AUTO - OOS This parameter is only used for service purposes.
Service -
Temp.Coeff.Sonic
Velocity
AUTO - OOS This parameter is only used for service purposes.
Amp. Device Type read only This parameter is only used for service purposes.
"Flow" Transducer Block / base index 1400:
Parameter
Write access
with operating
mode
(MODE_BLK)
Description
To Next Page
Loading...
